Boundary layer and loss analysis in a film cooled vane

The paper reports on boundary layer and wake flow analysis in a fully covered, film cooled vane without trailing edge ejection. The investigation, carried out in a low speed wind tunnel for linear cascades, has been mainly focused on the loss generation process due to coolant injection. The investigated region includes the rear part of pressure and suction side boundary layers and the wake region, up to a chord length downstream of the trailing edge. All measurements have been performed at mid-span, air being used as coolant flow. The same measurements have been also performed on a solid blade cascade, i.e. without cooling holes. Boundary layer profiles, integral parameters together with mean and turbulent quantities are presented. It results that the showerhead promotes transition on the suction side, giving rise to a thicker boundary layer all over the surface. On the pressure side, the boundary layer remains laminar up to the trailing edge, as high acceleration prevents transition. The wake region seems not to be strongly altered by the coolant injection. Boundary layer profiles and downstream 5-hole probe traverses have been used to compute loss coefficient distributions all over the blade surface and in the downstream region. Coolant injection strongly increases the profile losses along the suction side, while a much smaller contribution from the pressure side has been found. These increases are mainly due to coolant injection in the vane front part.